DIY - Customize your sweatshirt for this winter

• Print the template in real size.

• Cut it out.

• Fold the fur in 2 and pin the pattern on the back of the fur.
• Cut out

• Take the sweatshirt.
• Fold it in half on the middle and place a pin to indicate the middle.

• Protect the work surface.
• Position the collar against the table.
• Shake Odif Easy Custom.
• Spray Odif Easy Custom at 20 cm.

• Protect with parchment paper or a silicone craft sheet.
• Adhere with a dry iron on cotton setting and press firmly for 45 seconds minimum.
• Repeat this step along the collar.

• Take the ribbon.
• Fold it in half.
• Mark a mark at 14 cm from the folded edge with a pin.

• Open the ribbon so that the pinned mark is on the middle mark of the ribbon, hold with pins.
• Fold the free edges of the ribbon towards the center, secure with pins.

• Place the folded ribbon between two sheets of baking paper.
• Steam iron to mark the knot folds.
• Remove all pins.
• Iron again.

• Unfold the ribbon.
• Protect the ribbon with tape.
• Shake  Odif Easy Custom.
• Spray Odif Easy Custom in each corner.

• Remove the tape and fold the sprayed area down in the center.
• Place the knot between two sheets of baking paper and iron on cotton position for 45 seconds.

• Unfold the knot and spray with Odif Easy Custom, the central triangle.
• Reposition on the middle and then iron on cotton position for 45 seconds.

• Spray on the back and in the center of the knot with Odif Easy Custom.

• Place the back of the knot against the front of the sweatshirt.
• Protect with baking paper and iron on cotton position for 45 seconds.

Your new sweatshirt is ready